View Single Post
  #10 (permalink)   IP: 184.4.153.251
Old 12-28-2017, 10:01 AM
Terry64HT Terry64HT is offline
 
Join Date: Oct 2011
Location: Ontario, Canada
Posts: 174
Rep Power: 30
Terry64HT is on a distinguished road
Both old and new have the rubber molded onto the steel backing plate. The new reproduction seems surprisingly well-made. Just not made with the right mounting bracket. I'm pretty sure heat will not loosen the rubber enough to remove it intact, and I am reluctant to attack a new piece that costs a bit more than $50.
I'm willing to entertain hacking away at the back side if I thought it had a good chance of success, but I don't see much hope for a rubber pad removal.
Thanks for the suggestions, I'll keep looking for a solution.
Terry
64HT
Reply With Quote