tbirdforum.com

tbirdforum.com (https://www.tbirdforum.com/forums/)
-   Bullet Birds [1961-1963] (https://www.tbirdforum.com/forums/bullet-birds-1961-1963/)
-   -   62 Wiper Problem (https://www.tbirdforum.com/forums/bullet-birds-1961-1963/4271-62-wiper-problem.html)

microgeek_55 07-13-2015 01:16 PM

62 Wiper Problem
 
The wipers on my 62 have always worked fairly well. Have not used them much in the past couple of years. Got caught in the rain the other day and tried to use them. They jumped just a little and would not function. When I got home I found the ends of the two wipers had gotten hooked together somehow. I unhooked them and they both went up about 2 inches on the windshield and now they won't function at all, and they also wont go back down to the normal "parked" position. I have a 62 shop manual that doesn't have one mention of the wiper system in it. So, I have two questions; does anyone have an idea what might be the problem with the wipers, and does anyone know where I can get a manual that covers the wiping system?

waltreiss 07-17-2015 11:27 AM

If they are like the '63, they are powered by the power steering pump and fluid. I don't have the book with me to check, but might look under the power steering section in the shop manual to have a better understanding of the system...if they operate the same way.

Cheers,
Walt

waltreiss 07-20-2015 03:23 AM

Hey, I checked the 62 shop manual and I have to agree with you about there being almost no mention of the wipers. The supplement for 63 at least describes the power steering-driven wipers. The only reference I saw at all was about the fuse for the wiper motors. Good luck!

Garjus61 08-01-2015 12:31 AM

My '61 has electric wipers with a cam on the motor shaft that pushes the rod that moves the wipers. The clip that holds the rod on flipped off and so did the rod making the wipers inoperable. So although the wipers didn't operate I could hear the motor turning. You can reach the motor through the speaker hole, but it's tight and the cam and rod has to be in just the right place. I got the clip back on and it stayed on for a while then came off again. I got a "new" clip and when I took the dash out to replace the pad was able to get the clip on more securely. It's stayed on since. Don't know if yours is configured like this one but good luck!


All times are GMT -4. The time now is 07:00 PM.

Powered by vBulletin® Version 3.7.0
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Search Engine Friendly URLs by vBSEO 3.3.0

Garage vBulletin Plugins by Drive Thru Online, Inc.