View Single Post
  #5 (permalink)   IP: 174.112.208.107
Old 07-11-2018, 01:03 PM
Terry64HT Terry64HT is offline
 
Join Date: Oct 2011
Location: Ontario, Canada
Posts: 174
Rep Power: 30
Terry64HT is on a distinguished road
If I remember correctly, there are 3 loop type retainers attached to the back of the gauge assembly that you have to undo to get enough wire slack to work on the back of the gauges. There is also a sleeve type retainer attached with two nuts the goes across the bottom of the clock pod opening. I think I had to take the nuts off so it was free to move a bit.
It sounds a bit complicated, but really isn't too difficult to do.
Hope this helps
Terry
64HT
Reply With Quote