Forum: Flair Birds [1964-1966]
08-08-2012, 04:48 AM
|
Replies: 25
Views: 8,067
|
Forum: Flair Birds [1964-1966]
08-08-2012, 03:51 AM
|
Replies: 25
Views: 8,067
|
Forum: Flair Birds [1964-1966]
08-04-2012, 05:49 AM
|
Replies: 25
Views: 8,067
There should be some pins that look like...
There should be some pins that look like nailheads that the clips fasten to. The new clips will be a little tight at frist but that is what you want. When new top goes on fold the edge down so it...
|
Forum: Flair Birds [1964-1966]
08-02-2012, 10:11 PM
|
Replies: 25
Views: 8,067
Cruiser, be sure and check around rear glass...
Cruiser, be sure and check around rear glass channels. if you see any rust take a pick and see if has rusted to the inside of car. If not bad clean out and apply a rust inhibiter paint to stop it...
|
Forum: Thunderbirds For Sale/Wanted
07-17-2012, 06:56 PM
|
Replies: 0
Views: 2,100
1966 tbird landau
I have 2 cars, 1 is 80% complete on restore and other parts car. Both have clear titles and bills of sale. Many new parts. asking 4000.00for both and you come get. Do not have time to finish.may...
|
Forum: Flair Birds [1964-1966]
05-19-2012, 01:35 PM
|
Replies: 6
Views: 2,261
|
Forum: Flair Birds [1964-1966]
04-30-2012, 10:00 PM
|
Replies: 5
Views: 4,807
|
Forum: Flair Birds [1964-1966]
04-30-2012, 09:48 PM
|
Replies: 6
Views: 2,261
Trunk liner
I bought mine from Mac's and it fit perfect. You will need to fit it frist. Start with the upper wheel wells frist and glue them in place. I used 3M spray glue to hold in place. Then fit the rest of...
|
Forum: Flair Birds [1964-1966]
03-02-2012, 09:16 PM
|
Replies: 3
Views: 3,108
try some silicone spray on window channels,...
try some silicone spray on window channels, sometimes they need a little slickum to work properly. I had to replace both window motors in mine, a little tight at frist. Then I used a little silicone...
|
Forum: Flair Birds [1964-1966]
02-28-2012, 05:18 AM
|
Replies: 3
Views: 3,108
a switch is located on the back of inner door...
a switch is located on the back of inner door lock. Kinda a cam that opens when door is shut and closed when door is not completely closed. This makes a connection when door is not closed. Maybe...
|
Forum: Flair Birds [1964-1966]
02-14-2012, 07:39 AM
|
Replies: 12
Views: 3,714
master cly woes
Hi, I'm new to the Tbird forum but not to car repairs. I changed my brakes over because of safty reasons. with the daul cylinder you don't loose all of brakes if one side fails or gets a leak. My...
|
Forum: Flair Birds [1964-1966]
02-09-2012, 11:10 PM
|
Replies: 25
Views: 8,067
|
Forum: Flair Birds [1964-1966]
02-09-2012, 08:11 AM
|
Replies: 25
Views: 8,067
Harley, Cruiser, I found were wire went, It was...
Harley, Cruiser, I found were wire went, It was broken loose from bolt that holds bearing in column just above rag joint. That will go away from where its located to a easier place to get at. I will...
|
Forum: Flair Birds [1964-1966]
02-09-2012, 07:52 AM
|
Replies: 25
Views: 8,067
Harley. I will look again, I did not look at...
Harley. I will look again, I did not look at sterring column very close except on inside of the car. One of the last things on my list is to rebuild the sterring column, which will take place...
|
Forum: Flair Birds [1964-1966]
02-07-2012, 07:14 PM
|
Replies: 25
Views: 8,067
Thanks cruiser I'm still looking for the broken...
Thanks cruiser I'm still looking for the broken wire, my ride has cruise control thought it went there but it doesn't. I'm going to check some PDF's and see if maybe there was a switch on proportion...
|
Forum: Flair Birds [1964-1966]
02-07-2012, 07:38 AM
|
Replies: 25
Views: 8,067
strange wire
cruiser, I have a ground wire that is broken loose located on drivers side of carjust left of sterring section. It is grounded on fender well under master clyinder just where brake lines go to the...
|
Forum: Flair Birds [1964-1966]
02-07-2012, 07:01 AM
|
Replies: 25
Views: 8,067
vinyl top
The original replacment top for 66 comes with excess material so it can be trimmed to fit correct. I ordered mine from Macs with the correct grain material for less than two hundred. And it was a...
|
Forum: Flair Birds [1964-1966]
02-07-2012, 06:52 AM
|
Replies: 25
Views: 8,067
vinyl top
I did mine the original way, under drip rail and all other chrome related to car. The guy at the trim shop told the same thing about not going under drip rail, defeated my purpose of a full restore...
|
Forum: Flair Birds [1964-1966]
02-02-2012, 11:36 AM
|
Replies: 25
Views: 8,067
Hi bud
if you would like Email me at hughjd@msn.com or call 8033087659 my name is Donald Hughes.
|
Forum: Flair Birds [1964-1966]
02-02-2012, 06:54 AM
|
Replies: 25
Views: 8,067
Only if rust has eaten threw the roof metal on...
Only if rust has eaten threw the roof metal on rear and front windsheilds. Very expensive to do repairs the right way as I did mine and you got your work cut out for you. Big job!
Did mine while...
|
Forum: Flair Birds [1964-1966]
02-02-2012, 06:35 AM
|
Replies: 7
Views: 1,852
S bar
Hi , I'm new to the forum, I replaced the Vinyl top on my 66 and the S bars have a self threading 7/16 nuts behind the back of the bars(4). The interior panel where lights are will need to be removed...
|
Forum: Flair Birds [1964-1966]
01-28-2012, 07:37 AM
|
Replies: 5
Views: 2,627
|
Forum: Parts For Sale / Wanted
01-22-2012, 11:27 PM
|
Replies: 1
Views: 1,750
|
Forum: Parts For Sale / Wanted
01-22-2012, 11:02 PM
|
Replies: 0
Views: 1,250
66 town landua
I need a sterring wheel bumper pad that is good shape to fit with highway pilot switches on sterring wheel. If anyone has one and how much. color does not matter or would prefer black.
|
Forum: Parts For Sale / Wanted
01-22-2012, 10:56 PM
|
Replies: 2
Views: 1,094
|